+44 (0)1255 446 823 info@duracomposites.com

Dura Louvre Cladding installation Systems

Once you’ve selected your product type, colour and surface finish, it’s time to think about fixings. Dura Louvre uses a simple bracket sleeve to fasten the cladding to the substructure. The brackets are fixed to the substrate at set vertical or horizontal separations, and the Dura Louvre profiles are then fixed into the brackets. Various bracket sizes are available in both Cedar and Charcoal. Available dimensions and configurations are shown below:

Dura louvre Bracket example 1

Dura louvre Bracket example 2

Sample bracket sizes

The use of the louvre cladding brackets will be dependent on the width that is required for the application. If you require the cladding planks to be spaced further apart, then the bracket on the right will be used, whereas if you need the planks closer together, the bracket on the left will be used.


Composite Louvre Cladding in Teak, Cedar and Charcoal

Our louvre cladding planks are available in two colours. To check colour availability for product types, please visit the product range page. Colour samples are available on request, or for large orders, bespoke colours can be selected.

Please note that colours shown are representative only; actual colours may vary slightly. Whilst Dura Louvre Cladding is relatively colour stable, there will likely be some initial colour lightening as the product weathers, which typically occurs in the first 3 months.

For all UK cladding enquiries, please call:

01255 446 823

01255 446 836